SkyReal Documentation

  1. Accueil
  2. Docs
  3. SkyReal Documentation
  4. Oculus Configuration

Oculus Configuration


For using Oculus with SkyReal you will need:

  • The Oculus device
  • The Oculus Software (Link)



  1. Open configure Oculus rift window by running Oculus software, go to Devices and click on Configure Rift
  2. Read and click on “Next”
  3. Check everything is connected and click on “Next”
  4. Check USB3 supports Oculus is connected and click on “Next”
  5. Read and click on “Next”
  6. Fill the heigh of the person doing the configuration (from the bottom of the feet to the top of the head). Then, click on “Next”
  7. Read and click on “Next”
  8. Place the cameras at a distance of 1 to 2 meters and make sure that they are parallel to each other. Then, click on “Next”
  9. Read and click on “Next”
  10. Make sure the cameras can see one of your controller. Then, click 2s on the controller trigger.
  11. Go to the center of your room and click 2s on the controller trigger.
  12. Turn the controller until the camera are well place in the picture and click 2s on the controller trigger when its done.
  13. Click on “Next” to terminate the calibration
  14. Read and click on “Next”
  15. Stay clicked on the controller trigger and move to define the limits of the room with the selected controller. When it’s over, click on “Next”
  16. Read and click on “Next”
  17. Read and click on “I understand”
  18. Read and click on “Next”
  19. Read and click on “Next”
  20. Read and click on “Next”
  21. Calibrate the interpupilary distance by moving the button under the oculus from left to right. Then, click on “Next”
  22. Read and click on “Next”
  23. After everything has been configured, go back to Oculus, in the Parameter/General section, toggle “Allow unknown sources”.
Cet article vous a-t-il été utile ? Oui Non

Comment pouvons-nous aider ?